How to cut the bottom of the advertising engraving machine?

1. Set the layout: Open Wentai - set the layout size (measured by the meter ruler to measure the size of the black PVC board on the lower surface)

2, set the origin: Click [Options] - [Define the origin] - click on the bottom left corner of the layout - OK - right click to cancel the definition of the origin command

3. Drawing: Click [Graphics] - [Rectangle] - draw a rectangle at random - right-click this rectangle - modify the graphics parameters - set the width and height to the same size as the layout - click [Modify] - Click the Align toolbar on the right toolbar - Horizontal Center and Vertical Center to make the graphic coincide with the layout

4, do the path: select the graph - click [2D] - select the inscription, the depth of engraving (how deep is set to the depth of the next milling), the tool compensation is canceled, the engraving mode selects the horizontal milling bottom, click the tool magazine to select the straight knife {Add the randomly distributed bottom knife (width w1 is 20 height h1 to 10) and select } to cancel the secondary processing method - [OK]

5. Save the engraving path: Select the path to be completed - click [Save engraving path] - click [Search] to find the location to be saved, select the file type (*.nc) and click [Save] - Raise the distance to the general setting 5-10 - click [OK]

6. Import the completed path into the Weihong control application.

What is the meaning of the engraving machine milling bottom? The surface of the advertising engraving machine is horizontal so that the accuracy of the engraving of the workpiece can be preserved. Before the engraving machine leaves the factory, the engraving machine manufacturer debugging personnel have carved and milled the countertop, so the customer basically does not have to go to the milling table. However, many customers need to re-mill the surface if they use improperly damaged countertops, if the countertops are not flat, or if they are replaced with new ones.

The above is the meaning of the bottom of the advertising engraving machine, you should understand.

How to cut the advertising engraving machine?

1. The first possible problem is that the spindle and the table are not perpendicular. This requires the customer to make corrections so that the table top is perpendicular to the engraving machine's main axis. Consult the manufacturer for the specific calibration method.

2, the second problem may also be a problem with the knife, you can change the milling cutter to mill the table.

3. The third problem may be that there is a problem with the control card. If it is a problem with the control card, the control card is updated.

The above is the introduction of how to sculpt the advertising engraving machine, it is still very clear.