What should I do after the engraving machine is powered off? Use the material to face the knife, leaving a dot mark at the starting point every time, so I don't worry about the power outage. Waiting for the call, and then pointing the knife to the mark left by the previous one, from the new carving, but the table facing the knife, how to solve the problem of power failure in the case of power failure?
The advanced start is fine. Look at the current line number at the time of power failure. Fill in the line number of the previous point in the advanced start. Click OK, the machine will start carving at this line number. However, if you are carving something very fine, you will start carving from the beginning, and Z can only go down a few lines. If you continue to sculpt, you will see the seams of the sculpt. You will know when you try.
If it is a normal shutdown, the system will record the current position and serial number of the machine, but suddenly power off, the system can not save the current location, the serial number is also about the previous. The breakpoint continues, but the origin must be found again. If you have doubts about the current serial number, the most stupid way is to delete the original file and re-export it. It doesn't matter much, but you can't delete the bottom left corner because it is the origin.
