Engraving machine common faults and problems, the engraving machine manufacturers for you to analyze
Question 1: When you open the software, the computer prompts "Open the card to lose, please check the card" prompt.
Solution:
1. Check if the driver of the board is installed, or change the board to a PCI slot;
2. Reinstall the two data cables to see if there is any broken needle.
3. Weihong card has a problem, replace the card.
Question 2: Prompt when opening the software: three-axis alarm, initialize the fault signal.
Solution:
1. Check if the two data cables of the computer and the machine are connected;
2. Check if the fuse of the adapter board in the control box is burned out and replace the fuse;
3. Check if the power supply is normal.
Question 3: Misalignment when engraving, or wrong scale.
Solution:
1. See if the engraving software is correct or not;
2. Check the gap of the screw and the tightening screw of the polished rod.
3. Check if the settings of the software parameters are correct.
Question 4: When the X-axis is walking a certain section, the Z-axis does not raise the knife. Press it up and go down.
Solution:
1. Check if the Z-axis motor is running normally, the power and the current of the drive;
2. Check if the Z-axis motor line has poor contact or continuous condition
3. Check if the lift interval is set.
Question 5: The spindle motor does not rotate or rotate.
Solution:
1. View the settings of the parameters of the inverter;
2. Whether the signal line of the inverter is reversed.
Question 6: Presenting a sickle phenomenon.
Solution:
1. The power of the Z-axis motor is not good, and the coupling is loose;
2. The current of the Z-axis driver is too small, or the signal line is wrong.
3. The data line is not connected.
Question 7: When the software is turned on, the rendering axis is turned off.
Solution:
1. Problems with the drive or poor contact with the computer output signal line;
2. Poor motor line contact.
Question 8: The machine is not powered when it is turned on.
Solution:
1. Check if the launch button line is connected and the button is burnt out;
2. Check if the communication contactor is shorted or burned out.
Question 9: The axis only goes in one direction when the button is moving.
Solution:
1. Check if the data cable is normal and the data cable socket is plugged in.
2. Check if there is any solder joint on the motor circuit.
Question 10: The sending software can't be opened normally, and the engraving stuff is distorted.
Solution:
1. Reinstall new systems and software;
2. Check if the X, Y axis screw and screw are loose;
3. There is a problem with the engraving route
